Three-dimensional finite element analysis of single-lap adhesive joints under impact loads

Abstract

This paper deals with the stress wave propagation and stress distribution in single-lap adhesive joints subjected to impact tensile loads with small strain rate. The stress wave propagations and stress distributions in single-lap joints have been analyzed using an elastic three-dimensional finite-element method (DYNA3D). An impact load was applied to the single-lap adhesive joint by dropping a weight. One end of one of the adherends in the single-lap adhesive joint was fixed and the other adherend to which a bar was connected was impacted by the weight. The effects of Young's modulus of the adherends, the overlap length, the adhesive thickness and the adherend thickness on the stress wave propagations and stress distributions at the interfaces have been examined. It was found that the maximum stress occurred near the edge of the interface and that it increased with an increase of Young's modulus of the adherends. It was also seen that the maximum stress increased as the overlap length, the adhesive thickness and the adherend thickness decreased. In addition, strain response of single-lap adhesive joints subjected to impact tensile loads was measured using strain gauges. Fairly good agreements were observed between the numerical and experimental results.