Three-dimensional finite element analysis of geosynthetic-reinforced soil walls with turning corners

Abstract

The paper presents in-depth three-dimensional finite element analyses investigating geosynthetic-reinforced soil walls with turning corners. Validation of the 3D numerical procedure was first performed via comparisons between the simulated and reported results of a benchmark physical modeling built at the Royal Military College of Canada. GRS walls with corners of 90°, 105°, 120°, 135°, 150°, and 180° were simulated adopting the National Concrete Masonry Association guidelines. The behaviors of the GRS walls with corners, including the lateral facing displacement, maximum reinforcement load, factor of safety, potential failure surface, vertical separation of facing blocks, and types of corners were carefully evaluated. Our comprehensive results show (i) minimum lateral displacement occurs at the corner; (ii) lower strength of reinforcements are required at the corner; (iii) higher corner angles lead to lower stability; (iv) potential failure surface forms earlier at the end walls; (v) deeper potential failure surfaces are found at the corners; (vi) larger numbers of vertical separations are found at walls with smaller corner angles. The paper highlighted the salient influence of the corners on the behaviors of GRS walls and indicated that a 3D analysis could reflect the required reinforcement length and the irregular formation of the potential failure surfaces.