Abstract
Due to the spatial complexity and fabrication characteristics of offshore platforms, it is inevitable to encounter overlaps or proximity of weld lines in tubular joints. Several international standards such as American Petroleum Institute (API), American Welding Society (AWS), and American Institute of Steel Construction (AISC) regulate the minimum distance between primary weld beads; however, any logical and detailed background of this limitation has not been presented. For a non-compliant weld joint where the regulation is not met, fracture toughness calculation is a typical index to verify the structural integrity.This research consists of two parts. First, weld residual stress distributions are calculated by a 3D thermo-mechanical nonlinear Finite Element Analysis. Two crossing welds, a T-weld crossing on a butt weld, are simulated in one model. A separate tee and a butt welding simulations are also performed for a comparative purpose. Second, SIFs and J-integral values are calculated at the surface and deepest crack tip locations for four different types of semi-elliptical surface cracks. Four cracks are embedded into the weld model and the residual stress distribution from the 3D thermo-mechanical FEA are mapped to a 3D FE crack model as initial conditions. An additional axial tensile load is also imposed. SIF values are compared with those using the weighting function method for the butt weld model subject to three load cases, i.e., tensile stress only, weld residual stress only, and both of them. From the simulation, a tubular joint containing a chord girth weld intersected with weld beads of brace is found to show lower the SIF values than that having only a girth weld on chord.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call