Abstract
AbstractAlthough polymer blend nanocomposites are widely studied, the balance between stiffness and toughness has not yet been investigated in detail. Some materials producers as well as some sectors in the automotive industry try to improve the toughness of materials without an important loss in stiffness. With this in mind, the aim of the study reported here was to obtain a good balance between toughness and stiffness of polymer blends with different amounts of clay and compatibilizer. In this context, the microstructure of polyamide 6/ethylene–propylene–diene metallocene terpolymer/(ethylene–propylene–diene copolymer)‐graft‐(maleic anhydride) blends with various amounts of clay (2, 3, 4 and 5 wt%) and compatibilizer (10 and 20 wt%) was studied to analyse the achieved morphology to understand the macroscopic properties. The morphology of the rubber phase and the dispersion of the montmorillonite (MMT) are the main factors that influence the mechanical properties. In this sense, the highest Young's modulus is achieved for nanoblends with 5 wt% of MMT, although this nanoblend has the lowest value of notched Izod impact strength. The results obtained suggest that there is a clear trade‐off between stiffness, toughness and temperature behaviour when the ratio of (ethylene–propylene–diene copolymer)‐graft‐(maleic anhydride) to MMT is 5:1. Copyright © 2009 Society of Chemical Industry
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call