Test Point Insertion with Control Point by Greater Use of Existing Functional Flip-Flops

Abstract

This paper presents a novel test point insertion method for pseudo-random built -in self-test (BIST) to reduce the area overhead. R ecently, a new test point insertion method for BIST was proposed which tries to use functional flip -flops to drive control test points instead of adding extra dedicated flip - flops for driving the control points. Replacement rule used in the previous work has limitations preventing some dedicated flip-flops from being replaced by functional flip -flops. This paper proposes a logic cone analysis based test point insertion approach to overcome the limitations. Logic cone analysis is performed to find candida te functional flop -flops for replacing dedicated flip -flops. Experimental results indicate that the proposed method reduces test point area overhead significantly with minimal loss of testability by replacing the dedicated flip - flops. application to the inputs of the circuit -under-test (CUT). The output response analyzer compacts the output response of the CUT into a signature. T his provides a variety of benefits including the ability to apply a large number of test patterns in a short time (i.e., shorter test time) , at-speed testing, minimal automatic test equipment (ATE) storage requirements, test application in the field over t he lifetime of the part, and a reusable test solution for embedded cores. In particular, BIST is crucial for applications such as aerospace, defense, automotive, computer, etc., for the reliability of the entire system. The most economical logic BIST te chniques are based on pseudo-random pattern testing. On -chip input pattern generator constructed from a linear feedback shift register (LFSR) is most commonly used to generate pseudo -random patterns with its compact structure. And on -chip output response analyzer compacts the output responses into a signature and this allows significant compaction of test data. Pseudo-random pattern testing also can achieve high coverage of non-modeled faults which are not explicitly targeted during deterministic test ge neration. However, a major challenge is the presence of random -pattern-resistant (r.p.r.) faults which have low detection probabilities and hence may limit the fault coverage that can be achieved with pseudo -random patterns. There have been many research efforts to overcome the fault coverage limitation by r.p.r faults. Mainly two directions are given to enhance the fault coverage. One is to modify the pattern generator in order to generate patterns that detect hard faults. Various methods have been pr oposed such as weighted pattern generation ( 2), (4)-(8), pattern mapping ( 9)- (11), bit-fixing (12), bit-flipping (13), and LFSR reseeding (14)-(19).