Syntheses and gas transport properties of polyarylates based on isophthalic and terephthalic acids and mixtures of bisphenol A and 1, 1 bi‐2‐naphthol

Abstract

AbstractPolyarylates based on isophthalic (IA) and terephthalic (TA) acids and an equimolar mixture of the diols Bisphenol A (BPA) and 1,1 bi‐2‐naphthol (BN) were synthesized to produce BPA‐BN/IA and BPA‐BN/TA polymers and to measure their gas permeability coefficients, P(i), at several pressures and 35 °C, to the gases O2, N2, CH4, and CO2. For the BPA‐BN/IA membranes, at a 2 atm up‐stream pressure, the P(O2) and P(CO2) are 0.93 and 4.0 Barrers with O2/N2 and CO2/CH4 ideal separation factors of 6.7 and 27. For the BPA‐BN/TA, at a 2 atm up‐stream pressure, the P(O2) and P(CO2) are 2.0 and 9.9 Barrers with O2/N2 and CO2/CH4 ideal separation factors of 5.6 and 21. Comparing the selectivity–permeability balance of properties shown by the BPA/TA membranes with that shown by the copolymer BPA‐BN/TA, the balance moves in the direction of higher selectivity and lower permeability because of the incorporation of BN, which is a more rigid monomer than BPA. However, when the balance of properties for the pair O2/N2 shown by BPA‐BN/TA is compared with the one shown by other membranes such as those based on mixtures of diols and diacids, that is the bisphenol A‐naphthalene/I‐T polymers reported in the literature, the balance moves up and to the right of the typical selectivity–permeability trade‐off observed in the BPA‐polyarylate family. Thus, simultaneous incorporations of flexible and rigid monomers in both the diols and the diacids lead to more productive and more selective membranes. © 2005 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 256–263, 2006