Abstract
In this paper, we present a new method for gas sensing using the attenuation of surface acoustic waves (SAWs) as the measured quantity. For a NO 2-sensor employing this technique, simple delay lines on LiNbO 3 substrates were coated with copper or lead phthalocyanine as sensitive layer. The sensor signal is a change of the attenuation originating from surface conductivity changes induced by the adsorbed NO 2. The advantage of monitoring attenuation is that the amplitude of a surface wave is much less sensitive to temperature fluctuations of the device than the customarily employed SAW velocity. Therefore, high stability and sensitivity of the sensor to atmospheric NO 2 concentrations in the ppb range could be achieved. For field measurements, a compact electronic system was developed. Comparisons of the SAW sensor with other techniques like optical absorption spectroscopy or chemoluminiscence in several ambient air measurement campaigns were carried out. The results of the comparative measurements were found to agree well.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
