Structure and electrical properties of ITO thin films deposited at high rate by facing target sputtering

Abstract

High rate deposition of ITO thin films at a low substrate temperature was attempted by using a facing target sputtering (FTS) system. Deposition rate as high as 53 nm/min was realized on polycarbonate film substrate of 80-μm thickness. When the film was deposited at a deposition rate above 80 nm/min, polycarbonate film substrate was thermally damaged. The film deposited by FTS has much smaller compressive film stress than the film deposited by conventional magnetron sputtering. The film stress was reduced significantly by increasing the sputtering gas pressure and stress-free films can be obtained by adjusting the sputtering gas pressure. This may be mainly caused by the fact that bombardment by high energy negative oxygen ions to substrate surface during deposition can be completely suppressed in the FTS. Film structure and electrical properties changed little with substrate position, and uniform films were obtained by the FTS.