Abstract
Rare earth (Yb3+, Ho3+, Tm3+) yttrium disilicate phosphors were produced by sol-gel technique and heated at 1050 °C temperature. The sizes of the phosphors vary between 20-30 nm according to the images obtained from the Transmission Electron Microscope. The up-conversion (UC) emissions of the nanopowders were measured in the range of 500–900 nm wavelength under 950 nm laser excitation. A linear increase with power was observed in the emission intensity ratio depending on the laser excitation power. Using the FIR technique, the phosphor’s temperature was determined by the heating effect caused by the laser pump power. Due to the change in intensity ratio versus temperature, the temperature sensitivity at 428 K was calculated as 0.781x10-2K-1 and it was suggested that it can be used as a promising temperature sensor probe in photonic devices.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of the Turkish Chemical Society Section A: Chemistry
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
