Solid-state joining of aluminum to titanium: A review

Abstract

The dissimilar material joining of aluminum and titanium alloys is recognized as a challenge due to the significant differences in the physical, chemical, and metallurgical properties of these alloys, where the increasing demands for high strength and lightweight alloys in aerospace, defense, and automotive industries. Joining these two alloys using the conventional fusion techniques produces commercially unacceptable sound joints due to irregular, complex weld pool shapes, cracking and low strength, high residual stresses, cracks, and microporosity, and the brittle intermetallic compounds formation leads to poor formability or inferior mechanical properties. The formation of intermetallic compounds is inevitable but it is less severe in solid-state than in the fusion welding process. Hence, this article reviews on aluminum–titanium joining using different solid-state and hybrid joining processes with emphasis on the effect of process parameters of the different processes on the weld microstructure, mechanical properties along with the type of intermetallic compounds and defects formed at the weld interface. Among the various solid-state welding processes for aluminum–titanium joining, the following grades of aluminum and titanium alloys were employed such as cp Ti, Ti6Al4V, cp Al, AA1xxx, AA 2xxx, AA5xxx, AA6xxx, AA7xxx, out of which Ti6Al4V and AA6xxx alloys are the most common combination.