Abstract
Abstract This paper deals with rolling traction in isoviscous-rigid (IVR), piezoviscous-rigid (PVR) and elasto-hydrodynamic lubrication (EHL) regimes at line contact. First, a measuring method of rolling traction using the two-disk machine supported by ball bearings was explained. Then, the rolling traction in the IVR, PVR, and EHL regimes at line contact was measured. The measured results showed that as load P increases, the time average rolling traction FR AVG in the IVR and PVR regimes increases, while that in the EHL regime does not significantly increase. The measured FR AVG were lower than the rolling traction FR TED/CPA under the isothermal condition calculated by using the commercial software TED/CPA. To establish the rolling traction expression, a rolling traction expression under the isothermal condition FR iso was first derived by means of curve fitting the calculated FR TED/CPA. Then, a rolling traction expression (which takes into account the thermal effects of the inlet shear heating) FR thermal was derived by multiplying the thermal correction factor Ct to the expression FR iso. Finally, it was shown that the proposed expression FR thermal is effective for estimating the rolling traction in the IVR, PVR, and EHL regimes at line contact.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call