Reactive Extraction of Carboxylic Acids (Lactic, Propionic and Succinic Acids) using Tri-n-Butyl Amine Dissolved in Various Diluents

Abstract

The current study intends to look into the extraction of lactic acid, propionic acid and succinic acids from aqueous solutions of these substances utilizing various solvent-extractant combinations to ascertain the most effective composition for the reactive extraction. The commercial value of succinic, propionic, and lactic acids in industrial processes led to their selection as the carboxylic acids. The process of recovering carboxylic acids from their aqueous solutions is accomplished by the Process Intensification method of reactive Tri-n-Butyl Amine was employed in the experiments because it has better stability, a lower water solubility, and is more eco-friendly than other extractants of the amine type. The extractants were dissolved in various diluents with various chemical structures, including 1-octanol, chloroform, and dimethylene chloride. Each experiment was conducted at 298.15 K. The distribution coefficient (KD), loading factor (Z), and extraction yield (%E) were used to compare the results in the range of 0.1 to 0.4 N acid concentration at various concentrations of Tri-n-Butyl Amine (10% to 40%). It was observed that at 0.1N and 40% amine concentration succinic acid attains a maximum distribution coefficient KD is 8.01 and equilibrium complexion KE1 is 7.5 for Tri-n-Butyl Amine, followed by propionic acid and lactic acid and a (1:1) type of acid amine complex was observed. The kinetic studies that were carried out using stirred cells to figure out the kinetic parameters such as order of the reaction with respect to acid and amine, mass transfer coefficient, and rate constant are also reported. The reaction with the highest Hatta number, MH=14, occurs in an instantaneous regime in 1-octanol when succinic acid and Tri-n-Butyl Amine interact.