Abstract
Consistent results on an electron beam lithography instrument pose a major challenge in multi-user open-access nanofabrication laboratories. Calibration can be done using special and dedicated instruments, however, this is time consuming and expensive. We address this challenge by a carefully designed quality control procedure characterized using a scanning electron microscope. We inspect position accuracy, dynamic focus, and dynamic astigmatism, as well as single and multi-pixel lines in thin resist. Beam shape quality is inspected in the corners of the writing field at 6 different beam currents between 2 and 60nA. We use positive-tone resist AR-P6200 (CSAR 62) from All Resist. With our quality control procedure, we routinely write 11nm lines on a 40nm pitch, and obtain a field stitching accuracy better than 3nm and overlay accuracy less than 7nm.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call