Practical and simplified measurements for representative photovoltaic array temperatures robust to climate variations

Abstract

Listen

Translate article

A precise and practical power generation forecasting method for outdoor photovoltaic (PV) arrays and its performance evaluation are essential for advancements in solar power generation. Specifically, accurate temperature measurements of each of the PV modules in an array, the entire outdoor PV array, and the power generation system are crucial regardless of climatic and irradiance conditions. However, outdoor PV temperatures are often affected by environmental factors, such as wind direction, wind speed, solar irradiance, and outdoor air temperature fluctuations. Hence, the temperature data vary greatly depending on the measurement point of the module, which is affected by the above environmental factors. The variations of and uncertainties in temperature often extend over long arrays of PV modules common to large-scale PV systems. Therefore, it is necessary to establish a straightforward and reproducible inspection method to determine a single and robust representative PV module temperature for an array. In this study, we have established one such inspection method for outdoor PV arrays. It was observed that the temperature at the center of the array was closest to the average temperature regardless of the measurement period and climatic conditions; thus, it can be considered as the unbiased and robust representative temperature for the PV array. Moreover, lower irradiance conditions are better for accurate and repeatable PV module temperature measurements. The mean temperature differences of the PV array from its average measured at the center of the array were 0.2 °C for low irradiance and 0.5 °C for high irradiance. The temperature difference observed will have 0.1% to 0.2% impact on the power estimation for monitoring purposes.