Abstract
The control of intermetallic compounds (IMCs) poses a challenge in welding Al–Fe joints. To tackle this issue, power-modulated laser welding was utilized to join 6061 aluminum (6061Al) and AISI-304 stainless steel (304SS) in an overlap configuration. This research compares the impacts of two power modes: constant power (CP) and gradient power (GP) on weld formation and interface IMCs to demonstrate the superior performance of the GP mode. The GP mode alters the energy distribution pattern, resulting in distinct weld formation and interface microstructures compared to the CP mode. Notably, the research confirms that the GP mode enhances the tensile shear strength of the joints, highlighting the effectiveness of the GP mode.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have