Plasma-assisted surface modification of MXene/carbon nanofiber electrodes for electrochemical energy storage

Abstract

Inferior ion diffusion and relatively low electrochemically active sites of MXene-based electrodes make them becoming a major challenge to develop advanced electrode. Surface modification of electrodes using non-thermal plasma is a great way to suppress these challenges through providing more space for energy storage and facilitating the diffusion of electrolyte ions. Herein, the effect of nitrogen and oxygen plasma treatments on MXene/carbon nanofiber electrode is reported to enhance the electrochemical performance. In this work, Ti3C2Tx MXene/CNF composites were fabricated using a hybrid needleless electrospinning/plasma method for the electrochemical energy storage. Surface modification of the composites was performed by a DBD plasma reactor under N2 and O2 gases at low-pressure glow discharge as a two-step plasma treatment process. The results revealed that total pore volume and the surface area of the plasma-treated Ti3C2Tx/CNF composite increased considerably due to the N2 and O2 plasma treatments. It was found that the electrochemical active surface area of the N2/O2-plasma-treated Ti3C2Tx/CNF electrode enhanced by approximately two times compared to the non-treated one, leading to the specific capacitance of 162 F/g at 1 A g−1 in a 2 M KOH electrolyte. The increase in electrochemical activity arises from separate doping of N2 and O2 plasma, which not only improves the pore structure and wettability, but also modifies the electrical conductivity and capacitance of the electrode. The N2/O2-plasma-treated Ti3C2Tx/CNF electrode achieved excellent cycling stability with 124 % capacitance retention after 10,000 cycles, while the capacitance retention of the pure N2 and O2-plasma-treated Ti3C2Tx/CNF electrodes as well as the non-treated one were 111 %, 105 % and 98 %, respectively. Additionally, an asymmetric supercapacitor N2/O2-plasma-treated Ti3C2Tx/CNF//AC based on the N2/O2-plasma-treated Ti3C2Tx/CNF as a positive electrode and activated carbon (AC) as a negative electrode was successfully constructed, which demonstrated an energy density of 26.3 Wh kg−1 with a power density of 750 W kg−1 at the current density of 1 A g−1 with excellent capacitance retention (102 %) after 5000 cycles. This work provides a highly efficient method for the surface modification of MXene-based electrodes through non-thermal plasma treatment.