Abstract
An ink consisting of Pb(Zr0.53Ti0.47)O3 (PZT) particles with a median size of 170 nm and a narrow size distribution, in a dispersion of water and glycerol, and with a low viscosity and surface tension, was used for the fabrication of thick films by piezoelectric ink‐jet printing. This study reports the printing conditions, the subsequent thermal treatment of the as‐deposited layers, and the properties of the sintered PZT thick film. The film, sintered at 1100°C, had a locally dense microstructure and consisted of grains that are a few 100 nm across, as revealed by scanning electron microscopy. A local piezoelectric response of 15 pm/V was measured in the ink‐jet–printed PZT thick film by piezoresponse force microscopy.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have