Abstract
Tribonema biomass is considered promising biorefinery feedstock for the co-production of biodiesel and valuable bioproducts; however, the extraction of these useful compounds produces large amounts of algal residues, which produce increased environmental concerns. Herein, cellulose was extracted from the waste residue of T. utriculosum via alkalization and bleaching, followed by the production of high-value-added cellulose nanocrystals (CNCs) via acid hydrolysis. The hydrolysis was performed with 60% (wt%) H2SO4 at a yield of 13.31%, resulting in the generation of rod-shaped nanoparticles averaging 39.5 nm in diameter and 239.2 nm in length. The structural characterization analysis revealed that the prepared CNCs had high crystallinity (73.0%) due to the removal of non-cellulose components and amorphous regions by chemical treatment, as well as possessing good aqueous suspension stability (zeta potential = - 40.1 mV). Although the CNCs showed lower thermal stability than extracted cellulose, they spanned a broader temperature range due to two-stage degradation behaviour, with higher residue weight (16.7%). This work represents the first report on the preparation of a high-value-added industrial product, CNCs, from the filamentous microalga T. utriculosum, aiming to maximize benefits from waste algal residue reutilization.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call