Performance analysis of a conventional two-stage indirect evaporative cooler

Abstract

With the aim of saving a portion of the high-quality energy consumed in mechanical vapor compression systems for air conditioning applications, the present work focuses on utilization of low-quality energy conversion processes due to fluid evaporation. The conventional indirect evaporative cooler is selected based on its preference for further modification compared to a regenerative indirect evaporative cooler. It is configured to be operated with two identical stages in series. This task is achieved by developing a thermodynamic model to analyze the performance of the cooling unit and to indicate the extent of its development compared to the cooler in one stage. Preliminary results show that the best operating condition is when the ratio of primary air to secondary air is 1. The cooling unit produces fairly comfortable air within limited climatic conditions. It delivers air at 26 °C and lower even at climatic temperatures as high as 48 °C, but within a very low relative humidity range. The relative humidity range extends to less than 58% as the outdoor air temperature decreases. At high humidity levels (64 to 80% depending on climate temperature), cool air cannot be obtained at 26 °C, and the cooling unit performance is limited only by what the first stage produces. The average performance of the cooling unit exceeds that of the first stage by 42.6%. Increasing air flow rate leads to an increase in cooling capacity, but it also has a negative impact on supply temperature and effectiveness.