Perforation of AA5083-H116 aluminium plates with conical-nose steel projectiles—experimental study

Abstract

The interest regarding use of aluminium alloys in lightweight protective structures is today increasing. Even so, the number of experimental and computational investigations giving detailed information on such problems is still rather limited. In this paper, perforation experiments have been performed on AA5083-H116 aluminium plates with thicknesses varying between 15 and 30 mm impacted by 20 mm diameter, 98 mm long, HRC 53 conical-nose hardened steel projectiles. In all tests, initial and residual velocities of the projectile were measured and a digital high-speed camera system was used to photograph the penetration and perforation process. Based on these measurements, impact versus residual velocity curves of the target plates were constructed and the ballistic limit velocity of each target was obtained. An analytical perforation model from the open literature is then used to predict the ballistic limit velocity, and excellent agreement with the experimental data is found. The experimental results are finally compared to similar experiments on steel and concrete targets, and the capacity of the different materials is evaluated in relation to total weight.