Abstract
Photoconductive semiconductor switch (PCSS) allowing side illumination was fabricated on high purity semi-insulating (HPSI) 4H-SiC. A 532-nm pulsed laser with variable optical energy was used to trigger the PCSS. The performance of the PCSS was characterized under the two different load conditions, 50-Ω load and 0.05-Ω, with a current viewing resistor (CVR). The PCSS exhibited significantly different output characteristics for the two different loads. The equivalent resistance of the PCSS with the 50-Ω load, which was calculated from the output voltage and current, was inversely proportional to the optical energy, but the one with a 0.05-Ω load exhibited saturation behavior with the optical energy. While the times at peak output with the 50-Ω load were similar at various optical energies, the times at peak output with the 0.05-Ω load were dependent on the optical energy. Output current oscillation was also observed after the PCSS was turned off in the case of 0.05-Ω load condition. The different output characteristics for the different load resistances were analyzed using the transient response of the equivalent circuits. The PCSS exhibited a minimum on-state resistance of 0.27 Ω with the optical energy of 8 mJ and a maximum output current of 657 A at the bias voltage of 4.8 kV. The operating voltage of the PCSS was limited by surface flashover, which caused an additional output pulse following the first output pulse.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.