Abstract
To maximize biomass and lipid concentrations, various optimization methods were investigated in microalgal photobioreactor systems under mixotrophic conditions. Lipid concentration was estimated using unscented Kalman filter (UKF) with other measurable sources and subsequently used as lipid data for performing model predictive control (MPC). In addition, the maximized biomass and lipid trajectory obtained by open-loop optimization were used as target trajectory for tracking by MPC. Simulation studies and experimental validation were performed and significant improvements in biomass and lipid productivity were achieved in the case where MPC was applied. However, occurence of a lag phase was observed while manipulating the feed flow rates, which is induced by large amount of inputs. This is an important phenomenon that can lead to model-plant mismatch and requires further study for the optimization of microalgal photobioreactors.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.