Abstract
Additive manufacturing (AM) for printed electronics (PE), though still in its infancy, has seen major growth in the past few years. AM techniques have several benefits over traditional manufacturing, namely the reduction of waste material and the increased efficiency in producing prototypes. However, there are disadvantages associated with AM, the most prevalent being a low throughput of parts. Limited research has been done to increase the throughput to the scale of traditional manufacturing methods. To combine the benefits of both AM and traditional manufacturing techniques, this paper discusses a hybrid printed circuit board (PCB) assembly that employs an additively manufactured interposer to serve as a DC interconnect between the AM structure and the PCB manufactured with traditional methods.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.