Abstract
In this paper, we have considered the problem of optimal actuator and sensor placement for active large flexible structures and proposed a placement optimization method, which is based on balanced reduced models. It overcomes disadvantages arising from demanding numeric procedures related with high order structural models. Optimization procedure relies on H2 and H∞ norms, as well as on controllability and observability Gramians, which are related to structural eigenmodes of interest. Suggested methods for calculating approximate norms are advantageous due to their feasibility with large structures, where exact calculation of norms would cause numeric problems. A rule for determining optimal actuator/sensor placement in relation with actuation load modeling has been derived and proven by examples. The optimization procedure was documented by several examples showing a good agreement between the results obtained using different placement indices.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call