On-sun operation of a 150 kWth pilot solar receiver using dense particle suspension as heat transfer fluid

Abstract

Previous studies proved the Dense Particle Suspension (DPS) - also called Upward Bubbling Fluidized Bed (UBFB) - could be used as Heat Transfer Fluid (HTF) in a single-tube solar receiver. This article describes the experiments conducted on a 16-tube, 150kWth solar receiver using a dense gas-particle suspension (around 30% solid volume fraction) flowing upward as HTF. The receiver was part of a whole pilot setup that allowed the continuous closed-loop circulation of the SiC particles used as HTF. One hundred hours of on-sun tests were performed at the CNRS 1MW solar furnace in Odeillo. The pilot was tested under various ranges of operating parameters: solid mass flow rate (660–1760kg/h), input solar power (60–142kW), and particle temperature before entering the solar receiver (40–180°C). Steady states were reached during the experiments, with continuous circulation and constant particle temperatures. For the hottest case, the mean particle temperature reached 430°C in the collector fluidized bed, at the receiver outlet, and it went up to 700°C at the outlet of the hottest tube, during steady operation. A temperature difference between tubes is observed that is mainly due to the incident solar flux distribution heterogeneity. The thermal efficiency of the receiver, defined as the ratio of power transmitted to the DPS in the form of heat over solar power entering the receiver cavity, was calculated in the range 50–90% for all the experimental cases. The system transient responses to variations of the solar irradiation and of the solid mass flow rate are also reported.