Abstract
AbstractOnline measurements of the temperature and the diameter of fibers in the melt spinning process of thermoplastics are discussed. The temperature and the diameter of fibers can be applied in many fields such as fiber formation modelling, cooling rate behavior (Nusselt number), and rheological investigations (apparent extensional viscosity) of polymers. The online measurements along the spinline were carried out with an infrared camera during the melt spinning process. Two different experiments were designed and carried out to find the correction factor, i.e., the emissivity. The results show that the emissivity correction factor depends on the polymer type and the fiber diameter. Usually the diameter of the fibers is measured by an instrument or by direct velocity measurements invoking the continuity equation. In this new approach the diameter is found directly by the evaluation of the measured temperature. Therefore only one apparatus, namely an infrared camera taking snapshots, is required to find the fiber diameter. The key of this method can be seen in the temperature difference between the fiber and the environment. A mathematical procedure was developed to estimate the diameter of the fiber from the distribution curve. © 2004 Wiley Periodicals, Inc. Adv Polym Techn 23: 176–185, 2004; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/adv.20008
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.