Abstract
For a nearly flat indenter the “dead metal” cap solution is shown to require a smaller indentation load than that solution which involves material sliding over the die face even when the coefficient of friction in the latter case is much smaller than in the former.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.