Abstract
The results of calculations of the steady-state pressure for the direct extrusion of sheet under plane strain conditions through square and wedge-shaped dies are given. The results depend upon whether a dead metal zone is formed on the die face or whether the metal slips over the die face.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
