Morphometry of Boar Spermatozoa in Semen Stored at 17 °C—The Influence of the Staining Technique

Abstract

Simple SummaryTo obtain satisfactory results in artificial insemination, it is necessary to use high-quality ejaculates for the production of insemination doses and then maintain the biological value of the sperm during storage. Boar spermatozoa, owing to the specific structure of the cell membrane, are particularly sensitive to temperature changes. For this reason, cryopreservation cannot be used in artificial insemination practice, and there may be limitations to successful storage of semen in a liquid state. The practice of using boar semen for artificial insemination does not include analyses of the effect of storage time of boar semen on sperm dimensions. Therefore, the aim of the study was to analyse the morphometry of sperm during storage of liquid boar semen. An attempt was also made to evaluate the suitability of three staining methods for assessment of boar sperm morphometry. The morphometric dimensions of boar sperm were shown to change during storage of liquid semen. These changes affected the sperm head more than the tail and were due to the staining method used. The analyses are very important as they provide more information about the morphometric dimensions of the sperm during preservation of boar semen. The applied sperm staining techniques allows for a more accurate assessment of male reproductive cells.The aim of the study was to assess the morphometry of sperm during storage of liquid boar semen at 17 °C. An attempt was also made to evaluate the suitability of three staining methods for assessment of boar sperm morphometry. The study was carried out on 20 Landrace boars. Semen was collected from the boars every 5 days by the manual method. Four ejaculates from each boar were analysed (80 ejaculates in total). Analyses were performed five times: at 1 h, 24 h, 48 h, 96 h, and 168 h after semen collection. Blisters with insemination doses were opened immediately before the analyses. From each insemination dose, smears were prepared for morphometric evaluation of sperm, which were stained by three methods (eosin-nigrosin—EN, eosin-gentian—EG, and SpermBlue—SB). Morphometric measurements of 15 randomly selected sperm with normal morphology were performed on each slide. The morphometric measurements included the following parameters: sperm head length, width, area, and perimeter; tail length; and total sperm length. The results of the morphometric measurements were used to calculate the head shape index. The morphometric dimensions of the sperm were shown to change during storage of semen at 17 °C. The extent of these changes, however, depended on the staining method used, as the three methods result in different morphometric dimensions of sperm, in the case of both the head and the tail. In the slides stained by the eosin-nigrosin method, the dimensions of the head and tail were smaller at every time of storage than in the slides stained by the SpermBlue and eosin-gentian methods.