Modelling and simulation of surface formation in electrical discharge machining based on thermo-hydraulic coupling

Abstract

Surface formation in electrical discharge machining (EDM) involves melting, evaporation, re-solidification and crater overlapping. However, almost all existing models concerning surface formation in EDM only consider the thermal process and ignore hydrodynamic phenomena during machining. Herein, a novel three-dimensional thermo-hydraulic coupling model incorporating the arbitrary Lagrangian–Eulerian scheme was developed to address the above problem. The model comprehensively considered the surface deformation caused by melt flow, temperature-dependent material properties, phase changes and the effects of practical forces on melt pools to simulate surface formation on an anodic workpiece at a discharge current of 2 A. Simulation results demonstrate that during single-pulse discharge, molten material flowed radially to the crater periphery. The radial melt flow was driven by evaporation recoil pressure and thermocapillary force. The effect of evaporation recoil pressure on melt flow was gradually counteracted by that of surface tension after discharge ignition, and thermocapillary force became the dominant factor that maintained the existence of bulges around craters. During multiple discharges, the bulges generated by different discharges underwent superposition owing to the flow of molten material and subsequently formed surface peaks. The simulation results also provide the measurements of crater diameter, surface roughness and recast layer thickness, which are consistent with experimental results. The proposed modelling method can provide a useful reference for further investigations on surface integrity in EDM with minimal computing resource requirements.