Thermo-hydraulic analysis of melt pool dynamics and material removal on anode in electrical discharge machining

Abstract

The melt pool dynamics and material removal mechanism in electrical discharge machining (EDM) is not clear yet. In this study, a thermo-hydraulic coupling simulation model considering practical boundary conditions was proposed to investigate the melt pool evolution and material removal on the anode in EDM, with the simulated results directly verified by the high-speed observation of the discharge process. Discharge currents of 5–15 A, a discharge duration of 10 µs, and workpieces of zinc and steel were used in the model, with the forces acting on the melt pool comprehensively integrated and their effects on the melt pool dynamics and material removal analyzed. The simulation results show that on the anode the evaporation recoil pressure is one of the dominant factors that drive the melt flow and cause the molten material removal. The increase of discharge current results in larger evaporation recoil pressure, and thus larger volume of the molten material is removed. Under the effect of evaporation, obvious fluctuation of the melt pool will occur. Meanwhile, the evaporation recoil pressure oscillates with the melt pool fluctuation, which may induce a wave-like motion of the molten material and promote the generation of debris particles. Novel high-speed observation methods were proposed to observe the melt pool evolution and the material removal, with the observed melt pool behavior consistent with the simulated results. The observation also shows that the intermittent removal of the molten material occurs in the case of long discharge duration, which is considered to be caused by the intermittent increase of the evaporation recoil pressure during the melt pool fluctuation.