Improving the surface quality in wire electrical discharge machined specimens by removing the recast layer using magnetic abrasive finishing method

Abstract

This study explores the feasibility of removing the recast layer formed on aluminum alloy cylindrical specimens machined by wire electrical discharge machining (WEDM) by using magnetic abrasive finishing (MAF). The WEDM is a thermal machining process capable of accurately machining parts with high hardness or complex shapes. The sparks produced during the WEDM process melt the metal’s surface. The molten material undergoes ultra-rapid quenching and forms a layer on the surface defined as recast layer. The recast layer may be full of craters and microcracks which reduce service life of materials tremendously, especially under fatigue loads in corrosive environments. This investigation demonstrates that MAF process, can improve the quality of WEDM machined surfaces effectively by removing the recast layer. The present work studies the effect of some parameters, i.e., linear speed, working gap, abrasive particle size, and finishing time on surface roughness and recast layer thickness using full factorial analysis. Three-level full factorial technique is used as design of experiments for studying the selected factors. In order to indicate the significant factors, the analysis of variance has been used. In addition, an equation based on regression analysis is presented to indicate the relationship between surface roughness and recast layer thickness of cylindrical specimens and finishing parameters. Experimental results show the influence of MAF process on recast layer removal and surface roughness improvement.