Abstract
A high-performance class D audio amplifier using unipolar pulse-width-modulation (PWM) with double-sided natural sampling is presented in this article. In order to comprehend and design the system properly, the class D audio amplifier is modelled and analysed. A wide range triangle-wave signal with good linearity and magnitude proportional to supply voltage is embedded in the proposed class D audio amplifier for maximum output power, high power supply rejection ratio (PSRR) and low total harmonic distortion (THD). Design results based on CSMC 0.5-µm 5-V complementary metal–oxide–semiconductor process demonstrate that the proposed class D audio amplifier can operate with supply voltage in the range 2.4–5.5 V and supports 2.8 W output power from a 5.5 V supply; the maximum efficiency is above 95%, the PSRR is −82 dB, the signal-to-noise ratio (SNR) is 97 dB and the total harmonic distortion plus noise (THD+N) is less than 0.1% between 20 and 20 kHz with output power 0.4 W; the quiescent current without load is 1.8 mA, and the shutdown current is 0.01 µA. The active area of the class-D audio power amplifier is 1.5 mm × 1.5 mm.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
