Abstract
The paper discusses issue of selection of oscillatory shot peening parameters in terms of layout of microgrooves and surface coverage by the microgrooves. There are presented results of modeling and simulation of such method of burnishing, aimed at optimization of processing parameters. Computer program developed on the base of calculation algorithms for relevant parameters of the oscillatory shot peening should simulate conditions of real processing, creating possibilities to change of virtual machine tool parameters, comparing intentional effect of the processing with the one obtained in practice. Thanks to this, in a relatively short period of time it is possible to make selection of optimal parameters of the oscillatory shot peening with respect to surface covered by the Sr microgrooves in such type of microgrooves system.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
