Abstract
When an elastic body is heated rapidly, significant inertial stresses are developed if the imposed heating rates cause a substantial temperature change in times which are short relative to the mechanical response time of the body. This work describes a method for inducing and measuring the thermally induced elastic stress waves in an unrestrained thin rod. Rapid heating was accomplished electrically by discharging a low-inductance capacitor bank (0.1 μH, 2800 J) through the rod. Utilizing the frozen-stress technique, an initial fringe pattern was introduced into thin strips of a birefringent material securely bonded to each side of the rod. The longitudinal strain oscillations were measured by direct observation of the movement of the fringe patterns with a high-speed framing camera. Interpretation of these measurements required a dynamic calibration and application of a dynamic correction factor for the reinforcing effect of the coating. Oscillations with periods from 35 to 250 μsec and stress amplitudes up to 900 psi were measured and compared with the uncoupled thermoelastic theory. Good agreement was obtained, and it was concluded that this technique is suitable for transient measurements in the presence of large magnetic fields which normally restrict the use of electronic methods.
Submitted Version (
Free)
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call