Abstract
Homoepitaxial p-type CdTe films were grown by coevaporation of CdTe and phosphorus in vacuum, where the phosphorus vapor was ionized and accelerated toward the substrate. Hole densities up to 2×1017 cm−3 were obtained using an ion energy of 60 eV. Effects of residual ion damage were observed using cross-sectional transmission electron microscopy, etch-pit density, and minority-carrier diffusion length measurements. This ion damage is dependent on both the ion dose and the ion energy. Reducing the ion energy below 60 eV results in lower doping densities, but using electron irradiation and Cd overpressure during deposition makes it possible to achieve equivalent doping levels for 20 eV ions while reducing the ion damage. At an ion energy of 20 eV, using electron irradiation of the growing film, and a 0.2% overpressure of Cd, films with hole density of 1×1017 cm−3 and diffusion length of 0.35 μm were obtained. Photovoltaic behavior of the films deposited in different conditions was tested by fabricating n-CdS/p-CdTe heterojunctions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
