Abstract
This paper is to find the possibility of developing a new blend composite in order to produce a prototype for engineering application. The new palm oil based wax is a waste material produced from palm oil refining process. Recent prototyping activity, industrial blue wax is normally used to produce part prototypes from the machining process. Hence, the tensile strength of new palm oil based wax/LLDPE/Palm oil fiber blends was investigated. The result shows that the tensile strength of new palm oil based wax/LLDPE/Palm oil fiber blend was obtained is higher compared to the existing industrial blue wax. Machinability study covered surface roughness, chip formation characteristic, dimensional consistency and cutting tool wear. The higher tensile strength of the blend was selected to preceed for the machining test. The comparison results between LLDPE/palm oil based wax/ Palm oil fiber blends and Industrial blue wax were recorded. However, since the cost of this new palm oil based wax is lower, it will be an attractive option to replace the existing industrial blue wax for prototype application.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Review of Mechanical Engineering-IREME
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.