Abstract
Hot-electron currents and degradation in deep submicrometer MOSFETs at 3.3 V and below are studied. Using a device with L/sub eff/=0.15 mu m and T/sub ox/=7.5 nm, substrate current is measured at a drain bias as low as 0.7 V; gate current is measured at a drain bias as low as 1.75 V. Using the charge-pumping technique, hot-electron degradation is also observed at drain biases as low as 1.8 V. These voltages are believed to be the lowest reported values for which hot-electron currents and degradation have been directly observed. These low-voltage hot-electron phenomena exhibit similar behavior to hot-electron effects present at higher biases and longer channel lengths. No critical voltage for hot-electron effects (such as the Si-SiO/sub 2/ barrier height) is apparent. Established hot-electron degradation concepts and models are shown to be applicable in the low-voltage deep submicrometer regime. Using these established models, the maximum allowable power supply voltage to insure a 10-year device lifetime is determined as a function of channel length (down to 0.15 mu m) and oxide thicknesses. >
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.