Abstract
In this article a technique that allows derivation of the conversion matrix of a two-port device using a measurement setup based on a nonlinear vector network analyzer (NVNA), which is capable of identifying the optimum local oscillator (LO) level and the corresponding RF and IF terminations for a microwave mixer, is discussed and validated. This technique is applied to extract the conversion matrix of gate-pumped 0.2-μm pseudomorphic high-electron-mobility transistors (PHEMTs) driven by a 4.8-GHz signal at different power levels and using an intermediate frequency of 600 MHz. Several experimental results provide a behavioral description of the up- and down-conversion mechanism in microwave mixers and highlight the dependency of the conversion-matrix coefficients on the pumping signal amplitude and phase. Detailed validation of this technique is provided by means of a circuit-level simulation and its consistency by vector network analyzer (VNA) measurements. © 2006 Wiley Periodicals, Inc. Int J RF and Microwave CAE, 2006.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal of RF and Microwave Computer-Aided Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.