Laminar heat transfer and friction factor characteristics of carbon nano tube/water nanofluids.

Abstract

This paper presents an experimental investigation on the convective heat transfer and friction factor characteristics of CNT/water nanofluid through a circular tube fitted with helical screw tape inserts with constant heat flux under laminar flow condition. Nanofluids of 0.1% and 0.2% volume fractions are prepared by two step method. Thermo-physical properties like thermal conductivity and viscosity are measured by using KD2 thermal property analyzer and Brooke field cone and plate viscometer respectively. From the measurements, it is found that the viscosity increase is substantially higher than the increase in the thermal conductivity. The helical screw tape insets with twist ratios Y = 3, 2.44 and 1.78 are used to study the convective heat transfer and friction factor characteristics under laminar flow in the Reynolds number range of 520-2500. It is observed that, in a plain tube, maximum enhancement in Nusselt number for 0.1% and 0.2% volume fractions of nanofluids compared to pure water is 15% and 32% respectively. With the use of inserts, maximum enhancement in Nusselt number corresponding to twist ratios of 1.78, 2.44 and 3 are obtained as 8%, 16% and 4.6% for 0.1% volume fraction of nanofluid and 5%, 4% and 12% for 0.2% volume fraction of nanofluid when compared with water in plain tube. Thermal performance factor evaluation revealed that the values at all Reynolds number for all twist ratios and both concentration of CNT nanofluid are greater than unity which indicates that helical screw tape inserts with twist ratios considered are feasible in terms of energy saving in laminar flow.