Kinetics and Thermodynamics Study on Removal of Cr(VI) from Aqueous Solutions Using Acid-Modified Banana Peel (ABP) Adsorbents.

Abstract

Banana peel waste is abundant and can be utilized as a low-cost adsorbent for removing toxic Cr (VI) from wastewater. The acid modification of banana peels significantly enhances their adsorption capacity for Cr (VI). An adsorbent was prepared by treating banana peel powder with 50% H2SO4 at 50 °C for 24 h. The acid treatment increased the surface area of the adsorbent from 0.0363 to 0.0507 m2/g. The optimum adsorbent dose was found to be 1 g/L for the complete removal of Cr (VI) from 100 ppm solutions. The adsorption capacity was 161 mg/g based on the Langmuir isotherm model. The adsorption kinetics followed a pseudo-second order model. Increasing the temperature from 20 to 50 °C increased the initial adsorption rate but had a minor effect on the equilibrium adsorption capacity. Thermodynamics studies showed that the process was spontaneous and endothermic. The activation energy was estimated as 24.5 kJ/mol, indicating physisorption. FTIR analyses before and after adsorption showed the involvement of hydroxyl, carbonyl and carboxyl groups in binding the Cr (VI). The Cr (VI) was reduced to Cr (III), which then bound to functional groups on the adsorbent. Desorption under acidic conditions could recover 36% of the adsorbed Cr as Cr (III). No desorption occurred at a neutral pH, indicating irreversible adsorption. Overall, acid-modified banana peel is an efficient, low-cost and eco-friendly adsorbent for removing toxic Cr (VI) from wastewater.