Abstract

In this study, the root cause of a recurring corrosion problem at the tip of an internally cooled high-pressure turbine blade (HPT) of a turbofan engine was investigated. A two-pronged strategy was utilized involving (i) experimental techniques to identify the blade material and corrosion products, and (ii) computational methods to analyze the fluid flow over the blade. In the experimental thrust, an array of techniques was employed to determine the chemical composition, microstructure, corrosion products and microhardness values while the airflow, pressure distribution and thermal profile over the blade were found through computational paradigms. The blade was a Ni-based superalloy containing typical gamma (γ) and gamma prime (γ′) phases, with an average microhardness value of 389 HV at room temperature. SEM analysis of the corroded area revealed oxides of iron, calcium, magnesium, aluminium, and silicon (FCMAS) most of which were not part of the base alloy. To determine the temperature profile and pressure distribution on the blade, a conjugate heat transfer analysis using Ansys CFX was conducted. A combination of experimental data from the engine ground running test station and analytical equations was used to find the required boundary conditions for the computational analysis. Pressure distribution over the entire blade was found which showed higher flow velocities and cross flows at the blade tip which potentially cause erosion at that region in the presence of impurities in the incoming air. Temperature distribution over the entire blade was also obtained, and it was found that the highest temperatures for the internally cooled blade occurred at the tip region which were in the range of ∼1060 °C–1250 °C (average ∼1114 °C). The temperature on the tip was high enough to cause the melting of the impurities that ingress the coating and cause its degradation during thermal cycling. This exposes the base alloy to FCMAS and causes corrosion. These high temperatures (1060–1250 °C) also induced phase transformation and increased the brittleness (∼22 % increase in hardness) which aggravated the presence of corrosion and resulted in crack formation and blade rejection.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.