Investigation in improving the Cs-free negative hydrogen ion production with short-pulse low power in the afterglow of pulse-power-modulated plasma sources

Abstract

Listen

Translate article

Abstract Pulse plasma ion sources have been shown to be capable of achieving high negative hydrogen ion densities ( n H − ) or currents. The fast cooling of the electrons and reduction in the electron density (n e) provide favorable plasma conditions to improve the H− production, with a high density ratio of negative hydrogen ions to electrons during the pulse-off period. The purpose of this research is to further improve the performance of volume-produced H− ion sources based on the pulse power modulation. In this study, a time-modulated negative hydrogen plasma sustained by 10 kHz pulse power at the typical gas pressure of 0.3 Pa was numerically investigated using a global model. The model is compared with measurements obtained in a pulsed radio frequency ion source and shows a reasonable agreement. A steplike low-high power strategy in the active glow period and a short-pulse low power in part of the afterglow period are employed to mitigate overshoot of the electron temperature (T e) in the initial stage of the pulse period and to optimize H− production in the afterglow, respectively. The model predicts that a small-magnitude, short-duration low power operation in the afterglow increases n H − and decreases n e from the onset of the low power until the beginning of the next high power pulse, due to a modest temporary increase in the T e (less than 2 eV). It facilitates dissociative electron attachments and thus H− formation. The reduction in the n e indicates that positive ions lost to the walls cannot be compensated by weak ionization. H− production with a low number of co-extracted electrons can be optimized by adjusting the magnitude and duration of the low power in the afterglow.