Abstract
A process that enables us to improve the design of 2D centrifugal and helico-centrifugal pumps is presented. First of all, the definition of the impeller geometry as well as the analysis of its global performances are carried out starting from the mean streamline method (1D), based at the same time on ideal models and experimental correlations. A second stage of optimisation is achieved from a quasi three-dimensional (Q3D) method, by studying the meridional flow and blade-to-blade flow. Finally, 3D flow solution is performed by CFD tools. Nowadays, we have a group of tools which help the designers improve the performance of new machines. These digital tools are built around two computer programs, HELIOX developed for design and performance analysis in any centrifugal and mixed flow pumps equipped with volute or deswirl vanes, and also the module REMIX that gathers the meridional flow analysis and the simplified blade-to-blade one. To validate this procedure, a centrifugal machine with a volute (NS32) was modified and studied with it, and the results were simultaneously compared with the previous trial runs and with the software CFX-BladeGEN+ and CFX-TASCflow. The results for a machine equipped with a deswirl (VM51) are also presented.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Computational Fluid Dynamics
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
