Abstract
The problem of appropriate location of the sensors for identification of ingot – mould thermal resistance during continuous casting of metals is the subject of the paper. Analysed problem belongs to the group of inverse problems. The present work shows also the method of identification of unknown thermal resistance using the temperature measurements at the number of sensors located in the wall of the mould. The influence of the location of the sensors on the results of identification is analysed. The best location of the sensors results from the sensitivity analysis for the steady-state inverse heat conduction problem. Validation of the proposed inverse method is realized by comparison of the results taken from solution of inverse and direct problems. Several numerical examples are presented and analysed.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Computational Fluid Dynamics
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
