Abstract

Implosion and heating experiments at the Institute of Laser Engineering, Osaka University on Fast Ignition (FI) targets for the FIREX-1 project have been performed with Gekko-XII laser for implosions and LFEX laser for heating. We tried to reduce the prepulse level in the LFEX laser system and have improved the plasma diagnostics to observe the plasma in the harsh hard X-ray environment. A plastic (CD) shell target, 7-μm thick and 500 μm in diameter with a hollow gold cone was used in this experiment to guide the short-pulse laser at the time of the maximum compression. The shell target was imploded with 9 or 12 beams of Gekko-XII laser (527 nm) with energy of 300 J/beam in a 1.5 ns pulse. Two of the four LFEX laser (1053 nm) beams were injected into the inside bottom of the cone with an energy up to 0.7 kJ/beam in a 1.5 ps pulse at the time around the maximum implosion. We have observed neutron enhancement up to 3.5 × 107 with total heating energy of 300 J, which is higher than the yield obtained in the previous experiment in 2002 [R. Kodama et al. Nature 418, 933 (2002)]. We found the estimated heating efficiency is at a level of 10–20%. Fuel heating to 5 keV is expected when the full output of LFEX is used.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.