Abstract
In this work, the production of inhalable polymeric microparticles with modulable porosity is described. The starting polymeric material was the PHEA-g-RhB-g-PLA graft copolymer, which was suitably processed by spray drying (SD). Thanks to the addition of AB (weight percentage equal to 10 and 20 % with respect to the polymer) in the liquid feed, three biocompatible matrices were obtained with an increasing porosity in terms of pore volume (from 0.015 to 0.024 cc/g) and pore average diameter (from 1.942 to 3.060 nm), a decreasing tapped density values (from 0.75 to 0.50), and favorable aerosolization characteristics. These differences were highlighted also by a significant increase in the release of Rapamycin from the sample which showed the higher porosity (31.0 wt% after 24 hrs incubation) than the sample with the lowest porosity (14.9 wt%) in simulated lung fluid.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
