Influence of stimulus parameters on amplitude-modulated stimulus frequency otoacoustic emissions.

Abstract

The present study evaluated the influence of suppressor frequency (fs) and level (Ls) on stimulus-frequency otoacoustic emissions (SFOAEs) recorded using the amplitude-modulated (AM) suppressor technique described by Neely et al. [J. Acoust. Soc. Am. 118, 2124-2127 (2005a)]. Data were collected in normal-hearing subjects, with data collection occurring in two phases. In phase 1, SFOAEs were recorded with probe frequency (fp) = 1, 2, and 4 kHz and probe levels (Lp) ranging from 0 to 60 dB sound pressure level (SPL). At each fp, Ls ranged from Ls = Lp to Ls = Lp + 30 dB. Additionally, nine relationships between fs and fp were evaluated, ranging from fs/fp = 0.80 to fs/fp = 1.16. Results indicated that for low suppressor levels, suppressors higher in frequency than fp (fs > fp) resulted in higher AM-SFOAE levels than suppressors lower in frequency than fp (fs < fp). At higher suppressor levels, suppressors both higher and lower in frequency than fp produced similar AM-SFOAE levels, and, in many cases, low-frequency suppressors produced the largest response. Recommendations for stimulus parameters that maximize AM-SFOAE level were derived from these data. In phase 2, AM-SFOAEs were recorded using these parameters for fp = 0.7-8 kHz and Lp = 20-60 dB SPL. Robust AM-SFOAE responses were recorded in this group of subjects using the parameters developed in phase 1.