Abstract
Abstract A complete workflow of parameter development and process qualification of a part manufactured using laser powder bed fusion (L-PBF) AM technique requires data of porosity, pore morphology, distortion and static mechanical properties. Using a combination of two non-destructive techniques: Computed tomography and indentation testing, the influence of printing parameters on defect types and part density in L-PBF of Ti-6Al-4V is described. In addition, the results using the combined method are compared to conventional testing methods.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
