Effect of welding gas mixtures on weld material and bead geometry

Abstract

Abstract Shielding gas is an essential parameter in welding processes, serves to shield the molten material from the atmosphere and external contaminations while providing a stable electric-arc pathway during the process, thus influencing the quality of the weld bead and several other aspects of the process. Therefore, any welding-based process, such as wire-arc additive manufacturing, could benefit from shielding gas mixture optimisation to selectively improve the processing and possibly the final mechanical properties of the welded material. In this study welding of EN AW 5183 aluminium (single weld bead and wire-arc additive manufacturing build-up) was conducted using several gas mixtures and their influence on final geometry defects, and microstructure measured. The gas mixtures used were a combination of varying amounts of carbon dioxide, nitrogen, and oxygen. These were added to commercially available argon gas. It was observed that: CO2 additions led to an unfavourable bonding defect and increased mean grain size; nitrogen additions caused a decrease in mean grain size, decreased pore count while maintaining a similar pore volume fraction to the reference argon mixture samples; oxygen additions showed slight reduction of mean grain size, decreased pore count and decreased pore volume fraction. These results further showcase that varying shielding gas mixtures influence the final material properties and should be considered as an additional improvement route for conventional welding and additive manufacturing.